Page 6 - FINAL DRAFT_Neat

GII CENTURBO™ COMPRESSOR

COMPRESSOR DIRECT DRIVE SYSTEM
The MECO GII is the only true direct drive system on the market.Other compressors use intermediate couplings to connect the compressors
to the motor, which requires alignment, additional bearings, and dual circulating oil systems as well as external cooling fans and motors.
The impeller is mounted directly on the motor's shaft, so there is no alignment necessary. The compressor motor housing is water-cooled
and the bearings are air-cooled with only oil for lubrication. The GII size and weight means there is less torque
on the motor when starting up and less wear and tear due to imbalance.
COMPRESSOR REMOVAL
The GII can be completely replaced in less than two hours if necessary with minimal interruption in service.
The compressor is integrally mounted, eliminating the need for excessive ductwork and gasketing.

Advanced Lubrication Fewer Parts = More Run-Time
Integral Motor Drive Advanced lubrication means nomore storing The GII has fewer parts thanother industrial
We could not make it any gallons of oil,pumping, filtering, and cooling compressors andless than 10% of the parts
simpler. The impeller is with the associated controls. The air oil system of otherindustrial compressors. Since there are components in
attached directly to the motor eliminates all of this and uses only air and drops allrotating equipment that are subject to wear and replacement,
shaft eliminating the need for of oil to cool and lubricate the bearings. you will be glad that the GII has only two to four bearings and
flex couplings, sheaves, gear one steam seal.
boxes and their associated components.
Sanitary Surface Design
The impeller and suction bell are cast of inconel
Light Weight and 316 stainless steel and then machined to
The GII horsepower andweight varies according yield a smooth and homogeneous surface finish
to size and capacity. Relative to other industrial less than 25Ra. With suction bell mounted directly
compressors, the GII handling is an easy job. into the evaporator, there is no need for ducting or
casing drains.
Reduce Noise
At less than 80 dBa from It's Cool
three feet away, the Integral water cooling removes excess heat
MECO GII is the quietest rather than raising the ambient temperature in the
compressor in the utility room. It also provides for a much quieter
industry. A New Standard - Variable Output machine for a more comfortable operator experience.
With the GII the output of your distiller
varies with your demand reducing starts Compact Impeller
and stops and increasing energy With a small and lightweight diameter, the
efficiency to save your facility significant impeller transfers less loading on rotating
operating expense. elements such as the shaft and bearings.