Page 135 - FanPedia - By Twin City Fan and Blower
P. 135
FAN-PEDIA BEARINGS
Published by
Twin City Fan & Blower MOUNTING & ORIENTATION
©2017 TCF.COM
HOW BEARINGS CONNECT BEARING LOCATIONS (CENTRIFUGAL FANS W/ PEDESTAL)
TO PEDESTAL NOTE: Drive end “Outboard” bearing is set 3/4” in from end of pedestal top plate
NOTE: Non-Drive End bearing is also referred to as an “Inboard” bearing
Shaft Seal Bearing Shaft Cooler High Temp Angle
AKA: Heat Angle, Inverted Angle,
Spacer Angle
2 HOLE MOUNT
TCF Standard 2 hole mount:
Fan shafts 2-15/16 dia & below
Standard Temp Style Pedestal High Temp Style Pedestal with
with Standard Shaft Seal Standard Shaft Seal & Cooler
4 HOLE MOUNT
TCF Standard 4 hole mount:
Fan shafts 3-7/16 dia & above
NOTE: Some manufacturers can
offer only 2 hole or 4 hole mount
beyond these ranges. High Temp Style Pedestal High Temp Style Pedestal With Shaft Cooler
Stuffing Box or Mechanical Shaft Seals & Stuffing Box or Mechanical Shaft Seals
NOTE: Used for low temp applications 68