Page 758 - BPT Automotive & Truck Catalog

Vehicle products

The Perfect Tyre-Repair - Operation Instruction

Repairable zone:
Tread, the following table applies:
Vehicle type Vehicle Vehicle Truck/ C-Tyres Truck / AS / EM Motorcycle
Tyre type: up to 210 km/h up to 270 km/h and tyres with LI Tyres with LI of 123 up to 270 km/h
even Run-Flat-Tyres even Run-Flat-Tyres up to 122 and more
Tread damage: max. 6 mm max. 3 – 4 mm max. 6 mm max. 10 mm 2 – 3 grafts max. 3 – 4 mm
for each repair
Art.-No. 6470 4701 ● ●
Art.-No. 6470 4702 ● ●
Art.-No. 6470 4711 ● ●

1 Dismantle the tyre. Remove the object that caused the hole. Check 5 Pull the repair stick into the induction awl up through the centre.
the damaged spread. May not exceed up to back tyres (210 km/h) In case of repair sticks for front tyres, remove the red film
6 mm and 3 mm in front tyres (270 km/h) beforehand.Attention!
2 Clean the inner surface to a diameter of approx. 30 mm around the Prevent any impurity of the repair stick
damaged spot with 1K-ASK-Cleaner.
6 Apply a bit of rubber solution to the top of the induction awl.
3 Clean the hole duct with a square pricking awl.
4 Apply 1-2 drops of rubber solution the the eyelet of the induction
awl and insert it into the hole duct. Repeat this process 3 or 4
times.

7 Press the induction awl with the repiar stick into the hole until 8 Slowly pull out the insert awl and cutt off the overlapping edges
10 mm ofth repiar stick is visable. Then turn it 90° under pressure. of the repair stick aprrox. 3 mm above the profile.

9 Apply approx. 3 cm of the repair fluid plaster around the repair stick 10 Tyre can immediately be mounted.
from the inside.

Availability subject to country specific rules and regulations www.buypremiumtools.com 758