Page 27 - PBL71 OI/AXM630-EN AZTEC 600 SS (WIRO)

Aztec 600 ISE ammonia and fluoride
Single-stream ion-selective analyzers
10. Press the key and use the and keys to select 'Operate' followed by 'Prime lines and Calibrate' and press the key.
When the priming sequence is complete, a stabilizing period is initiated to allow the measurement cell temperature to stabilize. Once stabilized, calibration is performed automatically; the analyzer then enters measuring mode.
4 Getting Started
4.2 On-line Help
Fig. 4.1 On-line Help
If any alarms or messages appear on the operator screen, press the key to open the help at the relevant diagnostic help topic. For example, if the 'Calibration Failed' message is active and the help is opened, the help opens at the 'Calibration Failed' diagnostic topic.
1. Press the key and use the and keys to select 'Help'. Press the key to open the help.
2. To exit the on-line help, press the key until returned to the screen from where help was selected from.
Message Continued
OI/AXM630–EN Rev. J
23