Page 13 - PBL614 IM/SM500F-EN SM500F ( WIRO)
P. 13
SM500F
Field mountable paperless recorder
2.2.1 Panel-Mounting
Note. If removal of knockouts is required, refer to Section 2.3.1, page 15.
Referring to Fig. 2.4, secure the recorder in a panel as follows:
a Cut the correct sized hole in the panel – see Fig. 2.3, page 10.
b Insert the recorder into the panel cut-out.
c Screw one clamping screw into the left-hand bracket until 10 to 15mm of the thread protrudes from the other side of the bracket and position one clamp over the end of the thread.
d Holding the assembly together, position the bracket into the left-hand recess on the rear of the recorder case and secure with the bracket securing screw. Ensure that the plastic washer remains in the position fitted.
Repeat instructions 3 and 4 for the right-hand panel clamp assembly.
e Tighten the clamping screws evenly and securely by hand.
2 Installation
Note. This is critical in order to ensure proper compression of the panel seal and achieve the IP66/NEMA 4X hosedown rating.
Fig. 2.4 Installing the recorder – Panel-Mounting
IM/SM500F Rev. AA 11
