Page 24 - Microsoft Word - 2_Inch_Drain_Adapter_PDS_2016_01_05

®
™
DURO-LAST CLEAT PLATE

DESCRIPTION:
®
™
The Duro-Last Cleat Plate is a 0.035-inch (0.9-
mm) thick, 2-3/8-inch (60.3-mm) diameter galvalume
plate. The Galvalume finish has proven
weatherability and resiliency. Cleat Plates are
packaged and sold in quantities of 1,000.

Cleat Plates are stamped to include a recessed
0.265-inch (6.7-mm) diameter hole in the center and
a series of ribs for added strength. The configuration
of the ribs and the hole is used to prevent the screw
head from coming in contact with the Duro-Last
roofing membrane.
In addition to the stamped ribs, there are “cleats”
stamped into the plate to hold the Duro-Last roofing
membrane in place without tearing or puncturing the
membrane in high-stress load applications. Also,
because the cleats are not sharp, they are easier to
handle.

The Cleat Plate is a long-lasting and durable plate
that is available from Duro-Last, Inc.

INSTALLATION:
The Cleat Plate is installed with the “cleats” toward
the membrane.
When used with prefabricated mechanically
fastened systems, the Cleat Plate can be used for
securing Duro-Last membranes to the deck along
the prefabricated fastening tabs and the edges of
the sheet parallel to the tab direction. The Cleat
Plate must be installed with the edge flush to the
edge of the fastening tab.
®
When used with the Duro-Roof Roofing System,
the Cleat Plate must be installed along the center of
the 6-inch (152-mm) fastening tab.

When used with adhered systems, the Cleat Plate
must not be used for attachment of insulation or
cover boards.

www.duro-last.com 1 of 1 800-248-0280
Duro-Last, Duro-Roof and “World’s Best Roof” are registered trademarks owned by Duro-Last, Inc.
Created: 10/01/2005 Revised: 01/01/2009, 01/06/2016, 05/24/2016