Page 1235 - 2006 HARLEY FLSTCI SERVICE MANUAL

INSTALLING THRUST WASHER AND
3.10

BEARING RACE See Figure 3-28. Slide thrust washer (1) down balance sprocket shaft. Chamfer on thrust washer must face inboard (toward balancer). Slide bearing inner race (2) down balanceshaft as far as Install sprocket spacer (7) and sprocket (8) on balance- shaft and secure using flat washer (9) and nut (10). NOTE If not enough of the shaft threads are exposed to install the nut, remove the spacer (7) and then assemble sprocket (8) flat washer (9) and nut (10). Repeat step 5 using spacers/ washers to fully install bearing inner race and thrust washer. See Figure 3-28. Wrap a shop rag around balanceshaft to get a firm grip and also to prot

Y 1. 2. possible. 3. 4. 5. 6. 7. 8.
COUNTERBALANCER ASSEMBL

roller bearings rather than ball bearings used on other Softail
(3). The bearings on the sprocket end shaft are cylindrical
model engines. See Figure 3-28. A second thrust washer (5),
without chamfer on inner diameter, must be installed on roller
has a pressed on thrust washer (2) and inner bearing race
See Figure 3-27.The balance shafts in this engine are identi-
fied with a shallow drilled hole (1). The sprocket end shaft
Figure 3-27. Balance Shafts Refer to 3.30 COUNTERBALANCER ASSEMBLY in Softail Service Manual and perform all steps and remove/install thrust washers and inner bearing races as Remove inner bearing races and thrust washers from balance shafts following instructions in CAMSHAFTS AND CAMSHAFT BEARING in Softail Service Manual. and thrust washer from rear cam. NOTE Disregard reference to O-ring given in the rear cam proce- 2006 FLSTFSE 2 : Engine

1 Follow the procedure given for pulling inner bearing race

GENERAL 2 3 Identification mark Thrust washer Inner bearing race follows.

HOME bearing. 10955 1. 2. 3. 1. 2. dures. 3-24