Page 149 - 2006 HARLEY FLSTCI SERVICE MANUAL

TSM/TSSM enables starter relay. Password has not been P1009. ECM/ICM enters Password Learning mode for ten min- utes. Do not cycle ignition switch or interrupt vehicle be unsuccessful. This takes ten minutes ECM/ICM must not be allowed to shutdown. This takes ten minutes. ECM/ICM must not be allowed to shutdown. This takes ten minutes. ECM/ICM must not be allowed to shutdown.

NOTES learned. ECM/ICM sets DTC power or Password Learn will

Table 3-30. Setting TSM/TSSM and ECM/ICM Password

With ignition turned off, Check Engine Lamp and Security Lamp will be off. Lamp illuminate and then turn off. Engine starts and stalls. Check Engine Lamp illuminates and stays on. Security Lamp illuminates.

CONFIRMATION Verify Check Engine Lamp and Security

ACTION Ignition must be turned off for at least 15 Install new TSM/TSSM or ECM/ICM. Perform all steps under 3.3 TSM/TSSM VEHICLE DELIVERY. Set RUN/OFF switch to RUN. IGN key ON. Attempt normal start one time. Wait ten seconds. Security lamp will illu- minate and stay on. Wait until Security Lamp turns off. Quickly (within two seconds) turn IGN Wait until Security Lamp turns off. Quickly (within two seconds) turn IGN Wait until Security Lamp turns off. Quickly (within two seconds) turn IGN Turn IGN key OFF . Wait 15 seconds before turning IGN on. Turn IGN switch ON and start engine to confi

HOME NO. seconds. 1 2 Turn 3 4 5 6 7 key OFF-ON. 8 9 key OFF-ON. 10 11 key OFF-ON. 12 13 3-74