Page 266 - 2006 HARLEY FLSTCI SERVICE MANUAL

5-47

No voltage or voltage always ground on BE/GY wire. open between fuse NO Find and repair open on W/BK wire between connector [22] and relay.

NO. present. Check for 10-13 volts at Terminal 30 of the system relay. Voltage present? NO Check for continuity to Continuity present? NO Find and repair and relay. 2006 Softail: Engine Management (EFI)

YES Repair short to ground and replace ECM fuse. YES Repair short to ground and replace ignition fuse. NO Replace ECM. Reprogram and learn password.
Check for battery voltage at Terminal 87 of system relay (with relay installed) during first 2- 3 seconds after key ON. Battery voltage (10-13 volts) present for 2-3 seconds after key ON? 1 YES With ignition ON, check for 10-13 volts at Terminal 86 of the system relay. Voltage present? NO Was ignition fuse blown? NO Locate and repair open on GN/O wire. NO Replace system relay. Does fuel pump run for the first 2 seconds after key ON? YES System OK.

Test 5.14 (Part 1 of 3) SYSTEM RELAY: DTC P1001, P1003 YES System relay OK. Measure resis- tance (with relay removed) between Terminal 87 of the system relay and coil connector [83B] at Socket A. Is resistance less than 0.5 ohm? NO YES Find and repair Recheck connections. connection or Wiggle harness while open wire (Y/GN). repeating test. Repair intermittent. YES Measure resistance between Terminal 85 of system relay and cavity 4 on Breakout Box. Is resistance less than 0.5 ohm? YES Check for continuity to ground on terminal 4 on Breakout Box. Continuity present? YES Repair short

HOME 2