Page 289 - 2006 HARLEY FLSTCI SERVICE MANUAL

than 4.5V. Connect Breakout Box to connector [78B] leaving ECM disconnected. Check continuity between MAP connector [80B] Terminal C and Breakout Box cavity 14. Then measure continuity between MAP connector [80B] Terminal A and Breakout Box cavity 26. Resistance less than 1 ohm? NO Repair NO Locate and repair short between R/W and BK/W wires.
NO. Less open wire.

2 At some point in the flow chart you may be instructed to jump directly to a the box with the bold asterisk. Disregard the asterisk (but not the instruction box) if your normal pro- gression through the chart brings
YES Check resistance between MAP connector [80B] Terminal C and Breakout Box cavity 26. Resistance greater than 1 megohm? YES Replace ECM. Reprogram and learn password. you to this location.

Continued from Test 5.19 (Part 1 of 2). Check the 5 volt reference supply at the MAP sensor connector [80B]. With ignition ON, measure voltage between terminal C (R/W) and terminal A (BK/W). Voltage approximately 5.0 volts? NO. Greater than 6V. Locate short to 12 volts on R/W wire in wire harness. Repair as necessary. NO Locate and repair open on V/W wire. NO Locate and repair grounded V/W wire.

2 Clear codes using speedometer self diagnostics. 5.6 SPEEDOMETER SELF DIAGNOSTICS. Confirm proper operation with no check engine

Test 5.19 (Part 2 of 2) MAP SENSOR: DTC P0107, P0108 YES Connect Breakout Box to connector [78B] leaving ECM disconnected. OPEN CHECK: Measure resistance between MAP connector [80B] Terminal B and Breakout Box cavity 25. Resistance less than 1 ohm? YES SHORT CHECK: Measure 2 resistance between MAP con- nector Terminal B and chassis ground. Resistance greater than 1 megohm? YES Replace MAP sensor. See Softail Service Manual. See lamp. 2006 Softail: Engine Management (EFI)

HOME 2 5-70