Page 37 - 2006 HARLEY FLSTCI SERVICE MANUAL

See Figure 2-3. After security lamp turns off after being
illuminated for the first four second period, one of three

situations may occur. The lamp remains off. This indicates there are no current fault conditions or stored DTCs currently detected by the TSSM. The lamp stays off for only four seconds and then comes back on for an eight second period. This indi- cates an DTC is stored, but no current DTC exists. If the lamp remains on beyond the eight second period, then a current DTC exists. See CODE TYPES under 2.1 CHECKING FOR DIAG- NOSTIC TROUBLE CODES for a complete description of diagnostic trouble code formats. NOTE Some diagnostic trouble codes can only be fully diagnosed during actuation. For example, a problem w

1. a. b. c. 2. code. Figure 2-3. Check Engine and Security Lamp Operation
4 Sec. 4 Sec.
the security lamp will illuminate for approximately four
If the security lamp is not illuminated at Key ON, see 2.2
If the security lamp comes on late (after 20 seconds),
second period, see 2.2 INITIAL DIAGNOSTIC CHECK:
If the security lamp fails to turn OFF after the initial four
See Figure 2-1. “Key ON” means that the ignition key is
turned to IGNITION and the engine stop switch is set to
See Figure 2-2. When the ignition switch is turned ON,
2.2 INITIAL DIAGNOSTIC CHECK: SPEEDOME-
4 Sec. A Key ON 4 Sec. B Key ON 4 Sec. C Key ON

SECURITY LAMP If the turn signals flash six four-way flashes shortly after key ON, it indicates a diagnostic trouble code (DTC) has been logged sometime in the last three ignition cycles. To diagnose TSM/TSSM system problems, start by observing the behavior of the security lamp. NOTES RUN (although the engine is not running). seconds and then turn off. INITIAL DIAGNOSTIC CHECK: SPEEDOMETER. SPEEDOMETER. ON OFF ON OFF ON OFF 2006 Softail: Instruments

HOME TSM TSSM ● ● ● ● see TER. ● 2-2