Page 48 - 2006 HARLEY FLSTCI SERVICE MANUAL

2-13

NO “no rsp” displayed. See applicable code from other modules. Models not equipped with a tachometer will display “no rsp” normally. If “no rsp” displayed on odom- eter on tachometer equipped vehicle, see 2.4 SPEEDOME- TER. NO “end” displayed. To clear all DTCs for selected module hold reset switch for more than 5 sec- onds. If DTCs are not to be cleared, Press and release reset switch. Part number of module will be displayed. 2006 Softail: Instruments

DTC 2 displayed. Press and release reset switch. Are more DTCs displayed? YES

See 2.2 INITIAL DIAGNOSTIC

NO CHECK: SPEEDOMETER. Device response? YES “none” displayed. Press and release reset switch. Part num- ber of module will be displayed.

Figure 2-10. Speedometer Self Diagnostics

Speedometer Self Diagnostics (chart)
To display DTCs for the ECM/ICM, press and hold reset switch for more than 5 seconds. To display DTCs for TSM/TSSM, press and hold reset switch for more than 5 seconds. To display DTCs for speedometer, press and hold reset switch for more than 5 seconds. To display DTCs for tachometer, press and hold reset switch for more than 5 seconds.

1 Press and release reset switch again to continue to next module.
While holding odometer reset switch in, turn ignition switch to IGN. Make sure Run/Stop switch is in RUN position. Release reset switch. Does “diag” appear? YES Press and release reset switch. “PSSPT” appears. ”P” flashing. To choose TSM/ TSSM, press and release reset switch. ”S” flashing. To choose Speedometer, press and release reset switch. ”SP” flashing. To choose Tachometer, press and release reset switch. ”T” flashing. To choose ICM/ECM, press and release reset switch.

HOME