Page 102 - Roberston & Sinclair Catalogue
P. 102
Shank Type Tools
Carbide Tipped Router Bits
COMBINATION LAMINATING AND TRIMMING BITS
ACTUAL SIZE REFERENCE
ACTUAL SIZE REFERENCE
COMBINATION PANEL BITS
This bit drills its own hole through the laminate surface into precut opening then cuts out and trims in one operation.
– Cutters are usually with single flute. Cutters with two flutes
are referred to with “D” in their reference number.
LAMINATE TRIMMING BITS
This 2 flute 22° bevel bit is for small hand held trimmers fitted with a roller guide. A flat is on the shank for the clamp screw.
DIA CUTTER HT SHK
6.4 19 6.4 12.7 25 12.7 12.7 25 12.7 12.7 50 12.7
LAMINATE TRIMMING BITS
PART NO.
LINCP4 LINCP8 LINCP8D LINCP8DLR
DIA CUTTER HT SHK
10 25 6.4 10 40 6.4
PART NO.
LIN22B2 LIN22B2LR
DIA CUTTER HT
12 12 12 12 12 12
SHK ANG
6.4 22d 6.4 30d 6.4 45d
PART NO.
LINCSB2 LINCSB230 LINCSB245
SOLID CARBIDE SINGLE FLUTE LAMINATE TRIMMER
Solid carbide combination straight and 22° bevel cutters for small hand held trimmers fitted with roller guide. A flat is formed on the shank for the screw clamp.
ACTUAL SIZE REFERENCE
ACTUAL SIZE REFERENCE
Two flute combination bevel and flush trim in one bit. Best results are achieved with roller guide attachment.
DIA CUTTER HT SHK ANG
10 25 6.4
16 40 6.4 22d
COMBINATION FLUSH AND BEVEL TRIM BIT
PART NO.
LINCSB1 LINCSB1LR
ACTUAL SIZE REFERENCE
ACTUAL SIZE REFERENCE
SOLID CARBIDE PANEL PILOT BITS
This heavy duty combination flush trim and bevel bit is excellent for the professional laminate fabricator. It is designed for 1hp routers with turret stops. The B19 ball bearing guide removes the need for a fence. The cutter can be adjusted to cut flush and bevel in one operation. By raising and lowering the router head various cuts are possible. (1) Flush (2) Bevel (3) Flush and Bevel.
DIA CUTTER HT SHK PART NO.
26 25.4 6.4 LIN8130
The flush trim cutter makes a square cut, while the bevel trimmer make a 7 1/2° bevel on the laminate. 40mm (5/8”) overall.
DIA
6.4 6.4
CUTTER HT
6.4 6.4
SHK ANG
6.4 0.0d 6.4 7.5d
PART NO.
LINCPPF LINCPP7
KEY OD = Cutting Edge Diameter L2 = Cutting Edge Length (mm) Od = Shank Diameter (mm) L1 = Overall Length (mm)
All care has been taken to ensure information in this catalogue is accurate. However we reserve the right to make corrections without notification.
2-74