Page 8 - Preview

GENERAL INSTALLATION REQUIREMENTS
Electrical Requirements
The system has a universal power supply single phase 100 - 240 VAC: 50-60Hz. It must be used only with the supplied power supply.
Environmental Requirements
Corrosive materials can damage electronic parts; therefore, the System should only be operated in a non-corrosive atmosphere. For optimal operation of the System, maintain room temperaturebetween 5˚C to 30˚C, keep relative humidity atlessthan80%.
For optimal storage, maintain temperature between -20˚C to 60˚C, keep relative humidity at less than 90% and maintain Atmospheric pressure of 50kPa to 106kPa.
5. UNPACKING AND INITIAL SET UP UNPACKING THE SYSTEM
Unpack the system and verify that the components are intact and present. It is recommended to save the packaging box and materials for future transport.
Check parts according to the following the list in the previous Section GENEO X CONTENT LIST
NOTE: Checkthatthesystemandallitscomponentsareintact.Ifyoudetectanysignofdamage or a missing item, do not continue with the installation. Immediately report this to your Pollogen representative.
INITIAL SET UP
Follow these steps for simple plug and play set up:
Step 1 – placing the system:
Place the GENEO X on a stable surface which can support the weight of the system, (which is about 9Kg (~20 lbs.).
Step 2 – placing the cradle(s):
The screen mounted cradle Holder (for simplicity “holder”) has round marks on its top panel to indicate cradle positions (identified in Fig. 7). There are three possible positions for a cradle on the Holder. The GENEO X default configuration includes a single applicator, the Oxygeneo applicator and utilizes only the middle position. Upgrade kit of Ultrasound applicator, which is optionally purchased, will utilize the right position.
Fig. 7
Hold the Cradle with the opening towards the holder (Fig. 8), insert through like a bead and continue sliding it to the right side until it clicks into place. Click the Oxygeneo cradle in the middle position while covering the round mark entirely). Once the cradle is located in its proper place it will be “locked” into position.
Fig. 8
9