Page 192 - Gas Detection Systems Training Manual

Service stop screen (though target screen name shown above would be replaced by the Change Device ID Screen)- This screen appears immediately following a valid activation of the device summary or details screen device or zone ID labels shown previously. If the user presses abort, the service will restart and operation restored. Otherwise, once the service is stopped, the screen will transition to the Device ID Change Screen:
As shown above, both the zone and device IDs can be changed using either the slider bars or the number entry boxes. You will not be able to save the changes though until you press the “Validate” key. During validation, duplicate IDs will be searched both in the database and on the network- if found, changes will not be allowed to be saved and the message above the buttons will display this status. Otherwise, the message will indicate success and the “Save Changes” button will be enabled. To cause the changes to occur,
Sensor Electronics Corporation 5500 Lincoln Drive Minneapolis, Minnesota 55436 September 29th, 2006
Page 8 of 66
952-938-9486
SEC 3500 OI Supervisor Operator’s Manual Version 2.1.0095