Page 193 - Gas Detection Systems Training Manual

press the “Save Changes” button- the status bar will indicate the progress and status. Once successful, you may press the “Main Screen” button to return to normal operation.
4.2 Changing the Device Name
The process is nearly identical to changing the device IDs, except that the touch area/label is located just to the right of the device ID in the upper left-hand corner of the device summary and detail screens. Touching these areas likewise will stop the normal measurement loop and transition to the Change Device ID screen. Once completed and successfully changed in the device, the operation and screen will revert back to normal operation. The purpose and intent of naming each device is to create a meaningful tag that travels with the device and describes it enough to be distinguished from another similar device on your network. It can be any alpha-numeric text; hence it could be a serial number, a short name of its role, or some other method that you determine.
As in section 4.1 previously, the same screens contain the Device Name labels/touch areas, and if pressed and the Supervisor is logged in, the HMI will transition to the Change Device Name screen. Let’s examine the device summary touch zones (refer to the detail screens shown in section 4.1 and locate the Device Name fields- they operate the same and appear the same as the device summary screens):
SEC 3100 Sensor Device Summary Screen- Device Name Touch Zone
Sensor Electronics Corporation 5500 Lincoln Drive Minneapolis, Minnesota 55436 September 29th, 2006
Page 9 of 66
952-938-9486
SEC 3500 OI Supervisor Operator’s Manual Version 2.1.0095