Page 88 - CRESTRON HOME OS-3

Add a Gateway to the System

To add a gateway to the system and replace the Virtual Gateway, follow these steps:

NOTE:

l The DIN-DALI-2 must be connected via Ethernet to communicate with the Crestron
Home system.

l Use the DALI Commissioning tool in Crestron Toolbox™ software for managing the DALI
configuration. Only the DALI groups are imported into the Crestron Home system.
l The Cresnet® communication port on the DIN-DALI-2 cannot be used in the Crestron
Home system. Do not make connections to this port.

1. Tap Manage Gateways in the Device Types menu. The local network is scanned for
gateways that can be added to the Crestron Home system. Discovered gateways are
displayed in the Gateways on Network menu.

NOTE: Tap Recheck Network to scan the network for available gateways.

2. Select the gateway in the Gateways on Network menu and then tap the plus (+) button.

3. Enter a descriptive name for the gateway in the dialog box and then tap OK.
4. The gateway is added to the system and is displayed in the Gateways in System menu.

5. Configure the gateway after it is added to the room. Tap the gear button next to the
device name to display a Settings dialog box. For details, refer to Configure the Device
Settings (on page 677).

Remove a Gateway from the System

NOTES:

l Removing a gateway also removes all devices acquired by that gateway.
l Internal Gateways cannot be removed.

To remove a gateway from the system:

1. Select the gateway that you would like to remove.
2. Tap the back arrow (<) next to the gateway to remove it from the system. The gateway is
removed from the system and is added back to the Gateways on Network menu.

88 • Crestron Home™ OS Product Manual — Doc. 8525Z