Page 21 - OmniBeaconUserGuide_GDVersion
P. 21
The standard OmniBeaconTM is intended to be mounted using the 3/4” conduit tting which extends out of the bottom of the device. If you are replacing an existing alarm light with the OmniBeaconTM, and you have a large hole to cover, the OmniBeaconTM accessory plate can be used to cover the
hole as shown in Figure #1.
The metal plate should be sandwiched between (2) rubber gaskets to provide a complete seal.
NOTE: Do not attempt to cover a large hole without this plate. The siren on the bottom of the OmniBeaconTM is not weathertight and will allow water to leak into your control panel without the adaptor plate.
21
