Page 57 - Router Boss Manual

With the miters marked, mount a rail against the
pins with the corner of the tenon butted against the un-
derside of the base plate. Install a 1/2” diameter bit in
the router and set the depth to cut just shy of the pencil
line. Turn the router on and use the hand feed crank to
feed the stock into the bit and carefully trim the miter
as marked. Adjust the depth as necessary. Then repeat
these steps for the remaining rail miters.

Pins set at 45 º

Repeat the above process with the stiles, butting
the corner of the stile against the base plate.

57