Page 66 - IMER_2021-07_MPT_cat_en_Neat
P. 66
Sph
Tph
PRESTIGE ECO T Power
Eccentric screw plastering pump
Prestige Eco T Power 14.5 kW diesel engine Stage 5
1106130
Sph
Tph
Sph
• Yanmar liquid cooled diesel engine Stage 5
Eco T Power System: lower rotation speed ANTI-SHOCK control panel
Sph Tph
(2400 rpm) to reduce wear, lower fuel • Electromechanical selectors
Sph
consumption, lower noise • Standard hour counter
• Hydraulic transmission with piston pump with • Integrated electronic diagnostic
flow regulation system
• Cooling system with double air / engine coolant - • Hydraulic circuit pressure
air / hydraulic oil exchanger. control gauges
• Integrated 400 l twin cylinder piston compressor
Tph
Tph
Description Operation
The Prestige plastering pump is equipped with a Yanmar diesel engine and The mixture prepared in the efficient integrated mixer is poured directly
is ready to operate in complete autonomy with reduced consumption. The into the hopper and aspirated by the “Rotor-Stator” pumping system. The
exclusive “ECO T POWER” system adapts the engine revolutions based pump pushes the mixture into the hose until it reaches the opposite end,
on the power demand during the specific work phase, optimizing fuel where with the help of the powerful 400 l / min compressor and the spray
consumption and exhaust gas emissions. gun, the material is projected onto the application area.
Fully hydraulic operation with high efficiency variable displacement pump, The machine can be started and stopped directly via the air tap located
controlled by an electronic diagnostic system and simplified and ergonomic on the spray gun. Different accessories dedicated to spraying, controlled
control panel. pressure injections, fills or jets can be connected to the hose. In the case
of grouting or self-levelling screeds, “open hose” is used.
The ability to control the flow rate of pumped material from 0 to 60 l / min
offers great versatility. The pumping speed adjustment from 0 to 60 l / min allows to adapt the
pump also to applications where the quantities of product to be pumped
It is suitable for pumping and spraying: are small, such as in the case of:
• Traditional lime / cement plasters • Mortars for grouting
• Premixed/pre-dosed plasters based on cement/lime/colored plaster (Monokote) • Adhesives for thermal insulation coatings
• premixed / pre-dosed structural plasters • Decorative finishes for thermal insulation coatings
• premixed / pre-dosed restorative plasters • Waterproofing seal (only for large surfaces)
• Insulating plasters based on polystyrene or cork
• Mortars for grouting It is equipped with a forced mixer with horizontal axis with hydraulic
• Adhesives for thermal insulation coatings system to overturn the material in the hopper. In some applications where
• Waterproofing seal (only for large surfaces) the quantities of material to be pumped are significant, the Prestige can
• Mortars for fiber-reinforced reinforcement be equipped with a high-performance pumping unit and loaded directly
• Masonry mortar by a truck mixer or dumper.
• Binders / mortars for consolidation injections
• Filling grout with metal fibers / polypropylene / carbon / glass Equipped with a standard “2L6” pumping group, capable of satisfying
• Fiber-reinforced concrete (grain size max. 10 mm) most pumping and spraying needs, it can be further optimized for specific
• Self-levelling cement / anhydride based screeds needs, due to a wide range of optional accessories.
• Lightweight polystyrene-based screeds
• Fireproofing
• Refractory mortars (wet only)
Sph
• Shotcrete
Sph
64
Tph
Sph Tph
Tph
