Page 100 - Airblade® Dryer - Mix and Match

AIRBLADE® DRYER Mix and Match

Installation

10-Nozzle Frame Assembly: Wall Mounted

41) Once the motor is tightened down and in place you can mount the counter-clockwise Air
Cannon housing to the face plate on the motor. Place the housing on a 60° angle from
the upper beam to start and tighten it down. To do so remove the eight fasteners pointed
out in the image below and use them to secure the housing assembly to the motor
assembly.

60°

These fasteners are used to mount the Air Cannon
housing to the face plate on the motor and to
adjust the angle of the housing.
Adjustments can be made to the nozzle angle once the wash is ready to run a few test
vehicles.
42) Repeat steps 17, 18 and 19 for the driver side, but using the clockwise motor and
housing.

43) Locate the accessory box and remove the following fasteners. Also see image below to
determine clockwise from counter-clockwise impellers

Impeller Rotation is Referenced from
Item Qty
the Motor Side of the Impeller
3/8-16 x 2” HHCS 8
3/8” Lock Washer 8
3/8” Flat Washer 16
3/8-16 Regular Nut 16

Air Cannon™ Impeller Rotation

96 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681 1MANUL011