Page 8 - FreEsStyler® E-1032 Programming and Operation Manual

E-1032 PROGRAMMING AND OPERATION

Chapter 1 General Machine Operation

Door Control

The system has two means of controlling the doors. 1 is the built-in door controls, 2 is to program one Entrance
nd
st
Function and one Exit Function as Door Up Outputs. If the Enter / Exit Functions are programmed as UP commands,
an external door control system is responsible for closing the doors. If Built-In Door Controls are used, they can open
and close the doors. Built-In door controls can open wash in the morning and close it at night. It can also open the
doors during warm temperature and cycle them in cold temperature. When Built-In Door Control is utilized the door
control Photo-Eyes may also be used for any other wash feature that requires a Photo-Eye. Equipment locations
should be considered when using a single Photo-Eye for multiple purposes.

Note: Wash sends up and down signals but actual control should be performed by a
UL325 approved operator.

Typical Features of Wash

Non-Friction Applications

These are applications such as Soap, Spot Free, Triple Foam, Drying Agent, etc. these applications will typically turn
on, wait for Fill Time and finally move Carriage full travel. They can be configured to Purge then Dwell at the end of a
pass but this is not typical. The Carriage speed will change for front, middle and back as configured per that
package. The positions of the speed changes can be modified via E-1063 Advanced Configuration.
Top Wheel

From Front – If application started at the front of the vehicle the Top Wheel will turn on and lower as soon as the
application has started. It will remain on for the entire length of the vehicle unless the Enter Wheel-Anti Skunk is
operating. When the Top Wheel is on, the Carriage will travel further backward than normal to ensure that the Top
Wheel covers the entire top surface. The system will turn the Top Wheel off at the back of a cab if the vehicle is
detected as a pickup-truck.

From Back – If application started at the back of the vehicle the Top Wheel will be omitted. It will be omitted even if
the application has the Top Wheel Function on.
Exit Wheels

Operation is typical but can be modified via the E-1063.

From Front – if the Top Wheel is on with the application the Exit Wheels will not turn on and come in until they are
behind the front bumper. If the Top Wheel is not on with the application the Exit Wheels will turn on and come in
immediately. When they come in immediately care should be taken not to program too fast of a Carriage Speed.

From Back – Exit Wheels will turn on and come in immediately. Carriage will slow down when the wheels are close
to the front of the vehicle. They will stay at the slow speed for the entire time that the wheels are washing the front of
the vehicle.

1-2 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL226