Page 67 - QuickFire® Wrap Around Mix & Match

QUICKFIRE® WRAP AROUND

Maintenance

Trouble Shooting

Problem Solution
• See initial startup section (Adjusting Limit Switch)
QuickFire® Wrap Head does not walk
up the boom • Increase pressure as needed (see Adjusting Air
Regulators)
• See initial startup section (Adjusting Wheel Speed)

QuickFire® Wrap Head does not follow • See initial startup section (Adjusting Flow Control)
the vehicle
• Increase pressure if movement is too slow, decrease
if movement is too fast
• See initial startup section (Adjusting Sizer Limit
Switch)

• Check for missing pieces or damaged cleaning
Wobbling Boom or Shaft material

• Check Bearings for wear
• Check for bent shaft

Boom not pivoting inward • Confirm output is set to “AUTO” position
• Verify air feeds are in proper location

• Confirm that air is working properly on both sides of
air cylinder, rebuild or replace if necessary

Brush is turning too slow • Confirm flow control setting is all the way open
• Confirm hydraulic unit has 1000 – 1100 PSI
• Replace motor on hydraulic unit

Note: The pressure settings stated are for Conveyor speeds of approximately 100 vehicles per
hour. Different pressure settings may be needed to compensate for different Conveyor
speeds.

1MANUL825 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 63