Page 29 - Kondor® KL 2 - E-1063 Programming and Operation Manual

®
KL2: 1063 PROGRAMMING AND OPERATION

Chapter 3 Operator Interface/Programming

Setup

Setup / Misc
E-1063

PASSWORD RE-LOGIN LEVEL: The system allows for multiple levels of access. Each level requires a password.
Press the last word in the RE-LOGIN line (PASSWORD RE-LOGIN LEVEL NONE) to change the selection. Log-in
levels are shown above in the “Screen Key”. When a user presses the screen navigation keys, there will be an
automatic prompt to enter a password. Once the password is entered, access will be allowed for 5 minutes. If
more time is required, temporarily set the password Re-login level to NONE.
Example: If the Re-Login Level is 3 and a User has logged in at Level 3, the system would eventually time
out and restore access to Level 2. If the level is restored (reduced) to Level 2, then the User will be required
to enter a password to return to Level 3 access.
WEEP: This toggles between ON/OFF. ON enables the Weep function. MODE toggles between SCALED and
ON/OFF. For SCALED, the duty cycle is increased as the temperature decreases. When the system is in ON/OFF
mode, it is in constant WEEP for temperatures below 34° Fahrenheit.

TEMP SCALE: Here you can calibrate the Temperature Scale. A user can adjust temperature by + 9°/-15° of
what the sensor is reporting.

SONAR BACK ADDER: This is the number of inches after the Sonar reads the floor that will be considered
vehicle length.

SONAR FRONT ADDER: This is the number of inches before the Sonar reads the floor that will be considered
vehicle length.

ENTER SONAR LOADING DELAY: Typically, this setting is ZERO. This setting is the delay after loading that a
vehicle gets under the Sonar before the “Stop Light” will come on.

ARM TRIPLE FOAM: This setting toggles between the 3 and 6 color applications. It sets the amount of seconds
that each color pattern is dispensed. This control is not utilized by the XR-Pods.
XR TRIPLE FOAM: This setting toggles between Normal and 4-Applicator. Typically, it is set to NORMAL. 4-
Applicator is used when a “4-Application Point” XR has been installed. Not typical.

HIGH PRESSURE EXCHANGE TIME: This is the FILL TIME when the High Pressure application switches sides.

1MANUL128 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 3-9