Page 104 - MetroSelect Single-Line Configuration Guide

Activation Mode Features
~ Variable Laser-On Time Out – Scan this bar
³ 9 1 9 6 0 0 code with a code byte sequence (on page 16–1)
that represents the desired time out increment.
The configurable time increment (1-second
increments) selected is the scanning laser-on
time.

Allow Full Laser-On Cycle – The laser stays on
³ 1 2 0 3 1 4 for a full cycle even when a bar code is scanned
and transmitted.

Blinky Mode – The laser turns on after the
³ 4 1 8 3 2 4 selected activation trigger is detected. The laser
will blink on/off for approximately 30 seconds.

Transmit a NO READ Message on Laser Time
³ 1 1 8 1 1 1 Out – If the scanning cycle terminates without
scanning a bar code during the cycle, a NO READ
message is transmitted with the termination of the
scanning cycle.

Do Not Transmit a NO READ Message on Laser
³ 1 1 8 1 0 1 Time Out

Activate the LED during the NO READ
³ 1 1 8 3 1 1 Transmission – The LED is output with the NO
READ message.

Deactivate LED during the NO READ
³ 1 1 8 3 0 1 Transmission

Enable RTS No Read Pulse – A configurable
³ 1 1 9 9 1 7 RTS pulse width transmitted after the NO READ
message has been transmitted.

Disable RTS No Read Pulse
³ 1 2 0 3 0 3

22–2