Page 1116 - Foton Workshop Manual - Aumark (BJ1099)

34-86 AXLE AND PROPELLER SHAFT - REAR AXLE HOUSING ASSEMBLY

REPLACEMENT

1. Notices (Refer to "Chapter 34 Axle & Transmission Shaft - Rear Axle Assembly,
Notices")
2. Disconnect the negative cable of the battery (Refer to "Chapter 18 Starting &
Charging- Battery, Replacement")
3. Remove the rear wheel (Refer to "Chapter 33 Tire & Wheel - Rear Tire & Wheel,
Replacement")
4. Remove the rear brake (Refer to "Chapter 35 Service Brake- Rear Brake, Overhaul")
5. Remove rear wheel speed sensors on two sides (Refer to "Chapter 35 Service
Brake- Wheel Speed Sensor, Replacement)

6. Remove the rear axle assembly
(a). Disconnect the wheel speed sensor
harness from the rear axle.

(b). Disconnect the oil pipes of rear wheel
brake.
NOTICE:
• Notice: After the disconnection of brake oil pipes,
seal the oil pipes with plugs.
• The brake fluid is a corrosive substance. The
brake fluid dripped on the paint surface or rubber
part due to carelessness shall be cleaned with
water and wiped dry.

(c). Remove the fastening bolts of brake oil
pipes and disconnect the oil pipes from the
rear axle.

Page 1116