Page 1238 - Foton Workshop Manual - Aumark (BJ1099)

37-18 STEERING MECHANISM - STEERING COLUMN ASSEMBLY

(g). Remove the steering column assembly.
NOTICE:
When storing the steering column assembly, wrap
the upper and lower spline shafts with rubber
cover or soft cloth, or they may be damaged.

(h). Use a drill bit to drill a hole in diameter of
less than 0.5mm in the center of the
fastening bolt, unscrew the fastening bolts
with a broken bolt extractor, and remove
the ignition lock.
NOTICE;
The fastening bolts of the ignition lock are of one-
time bolt. Make sure to replace with new bolts at
the time of reinstallation.

8. Check the steering column assembly
(a). Check the spline shaft.
• Check for rust, damage or crack on the upper and lower spline shafts of the
steering column assembly.
• Check for distortion or damage on two or more teetch of the spline shaft.
If any, replace a new steering column assembly.
(b). Check the Steering Column.
• Check for distortion or crack on the steering column and replace it if needed.

9. Install the steering column assembly
(a). Install the ignition lock and unscrew the
ignition lock retaining bolts until the hex
nuts fall off.
NOTICE;
During tightening, tighten two bolts uniformly to
prevent the deflection of pressure plate.

Page 1238