Page 1273 - Foton Workshop Manual - Aumark (BJ1099)

POWER STEERING - STEERING GEAR ASSEMBLY 38-27

10. Check the steering gear assembly
(a). Check for crack on the steering gear. If any, replace the steering gear assembly.

(b). Check the contact mark between the
steering gear ball joint and the steering
knuckle arm.
With acontactmarkno Evenly apply red lead powder on the
greater than 3/4ofthe
ball joint pin length.
steering gear ball joint pin and inside the
mounting hole of the steering knuckle arm.
Insert the steering gear ball joint pin into
the mounting hole of the steering knuckle
arm and then remove it. Check the contact
fuwx38036 mark.
Standard : Even contact, with a contact
mark no greater than 3/4 of the ball joint
pin length.
If greater than 3/4 of the ball joint pin,
replace a new steering gear assembly
and a new steering knuckle arm.(Refer
to"Chapter 38 Power Steering - Steering
Gear Assembly, Overhaul"，"Chapter
34 Axle & Transmission Shaft - Steering
Knuckle,Overhaul")

(c). Check the dust cover on the two ends of
steering gear. 38
NOTICE:
If the dust cover is damaged, replace the Rubber
sleeve in time, to prevent wear and tear of the
steering gear.

11. Install the steering gear
(a). Install the steering gear and tighten the
retaining bolts of the steering gear.
Torque : 110~130N•m

Page 1273