Page 786 - Foton Workshop Manual - Aumark (BJ1099)

17B-8 LUBRICATION - ENGINE OIL

(c). Remove the engine oil pressure sensor
and install the engine oil pressure gauge.
40 60
20 80 (d). Start the engine to warm up and observe
the engine oil pressure gauge.
NOTICE:
• If the pressure reading is out of specified range,
check the engine oil pump.
• While installing the engine oil pressure sensor,
it’s necessary to apply sealant to the thread of
the sensors.
Model of sealant:
• After the installation of engine oil pressure
sensor, it’s prohibited to start the engine
fuwx17B010
immediately. Wait for the thread sealant to
solidify (approximate 10min) before starting the
engine.
(e). Stop the engine and wait for the engine to cool down before removing the engine oil
pressure gauge.
(f). Install the engine oil pressure sensor.
(g). Connect the connector of engine oil pressure sensor.

Page 786