Page 1917 - Foton Workshop Manual - Sauvana

CIRCUIT - SYSTEM SCHEMATIC DIAGRAM 61-127

System description:
With the ignition switch located at ON/ST, the current is output from the fuse F32 in the
internal fuse box to the pin 5 of the instrument cluster to supply the power. The current is
output from the battery, and after passing through the fuse F8 in the engine compartment 61
fuse box, it goes through the pin 1 of the front wiper high speed relay R11, and the pin 1
and pin 5 of the wiper low speed relay R10, and then is output from the pins 4 and 5 of the
relay R11 to supply power to the front wiper assembly.
LO position of front wiper switch
With the switch cluster front wiper switch located at the low speed position, the pin 8 of the
switch cluster is earthed, and the pin 8 of the switch cluster outputs the signal to the pin
D2 of the BCM connector C57 to provide the wiper low speed signal.The current is output
from the pin D4 of the BCM connector C57 to the pin 2 of the front wiper low speed relay
R10, and the relay R10 coil is electrified to generate a magnetic field to close the contact.
The current is delivered to the pin 5 of the front wiper assembly via the relay and is earthed
from the pin 4 of the front wiper motor to operate the front wiper assembly at a low speed.
HI position of front wiper switch:
With the switch cluster front wiper switch located at the high speed position, the pin 8 of
the switch cluster is earthed, and the pin 9 of the switch cluster outputs the signal to the pin
D3 of the BCM connector C57 to provide the wiper high speed signal;The current is output
from the pin D24 of the BCM connector C57 to the pin 2 of the front wiper high speed relay
R11, and the relay R11 coil is electrified to generate a magnetic field to close the contact.
The current is delivered to the pin 5 of the front wiper assembly via the contact 5 of the
relay 11 and is earthed from the pin 4 of the wiper assembly to operate the front wiper
assembly at a high speed.
Washer position of the front wiper switch
With the switch cluster front wiper switch located at the washer position, the current is
input into the pin 5 of the switch cluster and then into the pin 4 of the switch cluster, and
when the current is output to the pin 5 of the front washer motor, the washer motor will be
activated. Meanwhile, the current is output from the pin 5 of the switch cluster to the pin
E26 of the BCM connector C58 to provide signals to the front wiper.

：Parts Location

No. Reference harness No. Reference harness

A16 Engine compartment wiring harness C21 Front wall instrument wiring harness

A32 Engine compartment wiring harness C57 Front wall instrument wiring harness
A40 Engine compartment wiring harness C58 Front wall instrument wiring harness
A45 Engine compartment wiring harness M06 Tailgate wiring harness

C05 Front wall instrument wiring harness C56 Front wall instrument wiring harness

Page 1917