Page 518 - Foton Workshop Manual - Tunland (AT)
P. 518

04-372                     DIAGNOSTICS - ENGINE CONTROL SYSTEM

           THE COLD CAR STARTS DIFFICULTLY,THE CAR IS TREMBLED


                 Fault phenomenon                  Diagnosis logic                Possible reasons
                                                                            •      Poor quality of fuel
                                                                            •         Injector fault
                                            • Injector                      •    Leakage in the intake
      04
                                            • Intake system                              system
                                            • Fuel system                   •      Low fuel pressure
                                            • Coolant temperature sensor •        Block in the air filter
                                            • Intake mass flow sensor       • Coolant temperature sensor
                                            • Injection timing                            fault
            The cold car starts difficultly,
                                            • Intake heater                 • Intake mass flow sensor
            the car is trembled
                                            • Wrong mixture ratios                        fault
                                            • Carbon decomposition of       •    Electronic throttle fault
                                              cylinder valve and inlet      •       Block in fuel filter
                                              channel                       • Incorrect injection timing
                                            • Fuel quality                  •      Intake heater fault
                                            • ECM                           •    Too low of the cylinder
                                                                                 compression pressure
                                                                            •          ECM fault

           Diagnosis Procedure


           1 .    Check the engine data
           (a)    Ignition switch: OFF.
           (b)    Connect the diagnosis tool with the fault diagnosis connector (16 pins) on the lower
                  left of the dashboard.
           (c)    Ignition switch: ON, and start the diagnostic tool.
           (d)    Read the motor data shown on the diagnostic tool.

           Check whether the data flow is normal or not.

           YES>To step 2.
           No >Maintenance related faults.

           2 .    Check battery
           (a)    Start the engine, check battery voltage.

           Is the inspection result normal?
           YES>To step 3.

           No >Charge the battery or replace the battery.

           3 .    Check the starter
           (a)    Check whether the starter or the starter circuit has fault.

           Is the inspection result normal?
           YES>To step 4.

           No >Eliminate the problem and confirm that the phenomenon no longer exists.




                                                                                                         Page 518
   513   514   515   516   517   518   519   520   521   522   523