Page 2053 - Foton Workshop Manual - Sauvana
P. 2053

DIAGNOSIS-SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM (SRS)                    62-1
                 SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM


                 (SRS)

                 NOTICES

                                                                                                                    62
                 1.     This type of vehicle is configured with the SRS system. In case of operation not
                        following the correct steps, it may cause sudden expansion of SRS, and even result
                        in serious accidents. At the same time, in case of wrong operation for the SRS
                        system, it may also lead to the failure to work properly.
                 2.     Always confirm to turn off ignition switch to "LOCK" position, and don't carry out the
                        operation until 90s after disconnecting the battery positive and negative cable. (The
                        supplemental restraint system is configured with a backup power supply, therefore
                        if the operation is carried out within 90s after disconnecting the battery positive and
                        negative cable, it may cause the sudden expansion of SRS.)
                 3.     Never make the horn button assembly exposed in the hot air or open fire.
                 4.     Because it is hard to identify the symptom for the SRS system, diagnostic trouble
                        code (DTC) will be taken as the most information source when troubleshooting.
                        Therefore, during troubleshooting for the SRS system, always detect the diagnostic
                        trouble code (DTC) before disconnecting the battery.
                 5.     Even if the impact is very small and the airbag assembly is not expanded, the horn
                        button assembly and air bag ECM shall also be checked.
                 6.     If it may have an impact on the SRS control module ECM at the time of
                        maintenance, always disconnect SRS control module ECM connector firstly.
                 7.     Never use the SRS system parts and components removed from another vehicle. If
                        the replacement is needed, always use the new parts and components.
                 8.     Never disassemble horn button assembly.
                 9.     If the horn button assembly falls to the ground, or cracks, pits, or other defects
                        appear on the shell, always replace it with the new parts and components.
                 10.    A high-impedance multimeter shall be used for the system circuit fault check.
                 11.    The parts and components of the SRS system carry the explanatory information
                        labels, and always follow the precautions on the label in the process of
                        maintenance.
                 12.    Always check the SRS indicator light after completing the operation of the SRS
                        system.
                 13.    After disconnecting the battery negative cable, the memory of electronic clock
                        and audio system will be cleared. All necessary data shall be recorded before
                        maintenance. At the end of maintenance, reset the audio system and adjust the
                        electronic clock. Never try to use the backup power supply outside of the vehicle, so
                        as to avoid the loss of data in each memory of system. The backup power supply
                        will supply power for the SRS system, it may cause a sudden expansion of SRS at
                        the time of maintenance.








                                                                                                     Page 2053
   2048   2049   2050   2051   2052   2053   2054   2055   2056   2057   2058