Page 405 - Foton Workshop Manual - Sauvana
P. 405
ENGINE MECHANICAL - VALVE 12B-115
INSPECTION
1. Check the valve components
(a). Measure the thickness of the top center of
the valve tappet.
12B
(b). There is an identification label on each
valve tappet at the position shown in the
fig.
(c). If the measured value does not conform
to the standard value, replace the valve
tappet according to the identification labels
and the diagrams below.
For example:
If the identification label on the tappet is
"322", the corresponding thickness
should be 3.22mm.
Page 405
