Page 433 - Foton Workshop Manual - Sauvana

ENGINE MECHANICAL - CRANKSHAFT OIL SEAL 12B-143
CRANKSHAFT OIL SEAL

REPLACEMENT

1. Remove the front oil seal from the
crankshaft
(a). Turn the vehicle shift handle to gear five.
(b). Remove the drive belt of the generator.
(Refer To"Chapter 12B Engine Mechanical
Systerm - Drive Belt,Replacement")
(c). Remove the fixed bolt of the crankshaft belt
pulley, and remove the crankshaft belt 12B
pulley.

(d). Extract the front crankshaft oil seal.
NOTICE:
• Oil seal shall not be used again after being
taken down, a new oil seal should be used for
installation.
• Do not scratch the oil seal installation hole of the
sprocket chamber cover when extracting the oil
seal.

2. Install the crankshaft front oil seal
(a). Install the oil seal on the sprocket chamber
cover by using the installation tool of the
crankshaft oil seal.
NOTICE:
• Before installing the front oil seal of the
crankshaft, a layer of oil should be applied to the
lip.
• When pressing the oil seal, the end surface of
the oil seal should be flush with the inner shell of
the sprocket chamber.

Page 433