Page 878 - Foton Workshop Manual - Sauvana

21A-36 TRANSMISSION - SECOND SHAFT ASSEMBLY

(c). Install the third/fourth gear synchronizer
assembly from the second shaft.

(d). Install the circlip with circlip pliers.
NOTICE:
• Before installation, check for distortion of the
circlip and replace it if needed.
• Select the right circlip so that the radial
clearance of the synchronizer gear base meets
the standard.

16. Install the reverse gear assembly
(a). Install the reverse gear needle bearing.
NOTICE:
• When installed in the gear, the needle bearing
shall be no higher than the gear end, or check
the installation position or replace the bearing.
• When installing the needle bearing, shake it and
check for missing needle. Replace it in case of
any damage.
• During installation, apply some lubricant to the
needle bearing, to avoid wear caused by dry
friction.
(b). Install the reverse gear.

Page 878