Page 1341 - Workshop Manual - Tunland (2017)

ENGINE MECHANICAL - ENGINE ASSEMBLY 15-5

ENGINE ASSEMBLY

REPLACEMENT
CAUTION

• Before disassembling the engine assembly, drain up all the fluids in the engine
and disconnect the harness, pipe fittings and connections between the engine
and the body.
• Before disconnecting all harness and pipes, mark them properly to prevent 15
mismatching or missing harness and pipes during installation.
• Once a fitting is disconnected, seal the opening to avoid foreign objects from
entering.
• All drained fluids must be collected and handled as required. Keep the site clean
and neat.

1 . Discharge the pressure in the fuel system. (Refer to "Chapter 12 Fuel - fuel
system, precaution")
2 . Disconnect and take out the positive and negative battery cables. (Refer to
"Chapter 20. Starting & charging - battery, replacement")
3 . Drain the engine oil. (Refer to "Chapter 05 Vehicle maintenance - Replacement,
engine oil and oil filter replacement")
4 . Drain the coolant. (Refer to "Chapter 05 Vehicle maintenance - Replacement,
coolant replacement")
5 . Collect the refrigerant. (Refer to "Chapter 61. heating & A/C - refrigerant,
replacement")
6 . Drain up the hydraulic oil in the power steering tank.

7 . Screw out the engine fuel cap, and pull out
the engine hood.

8 . Disconnect the harness connector and the grounding harness: