Page 158 - Workshop Manual - Tunland (2017)

04-20 DIAGNOSTICS - ANTI-LOCK BRAKING SYSTEM (ABS)

(b) Measure the resistance of the connectors of
the harness as per the values given in the
table below.
Standard electrical resistance (check
whether there existent an open circuit)

04 Connection of the
Standard value
multimeter
A006（18）-B003（1）

A006（31）-B003（2）
＜2Ω
A006（29）-B002（1）

A006（17）-B002（2）

(c) Measure whether there is short circuit in the
resistance between harness pins
Standard voltage

Connection of the Standard value
multimeter

A006（18）- ground

A006（31）- ground
≥ 1 MΩ
A006（29）- ground

A006（17）- ground

Check whether the result is normal?
Yes >Maintain or change the ABS control module.

No > Maintain or replace the harness and connectors

5 . Check right rear, left rear wheel speed sensor installation
(a) Check right rear, left rear wheel speed sensor installation.
CAUTION

The installation bolt shall be fastened appropriately, and the position of installation
of sensor should be leveled.

Check whether the result is normal?
Yes> go to step 6
No > maintain or replace the wheel speed sensor

6 . Check right rear, left rear wheel speed sensor signal terminal