Page 928 - Workshop Manual - Tunland (2017)
P. 928
04-242 DIAGNOSTICS - ENGINE CONTROL SYSTEM
04 (f) Use a multimeter to measure the resistance
between the pin 4 of DPF temperature sensor
connector Q01 and the ground.
Standard voltage
Multimeter connection
Standard value
pin
Q01（4）-ground Battery voltage
Is the inspection result normal?
YES>To step 3.
No > Maintain or replace the harness.
3 . Check DPF temperature sensor harness
(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Disconnect DPF temperature sensor connector Q01.
(d) Disconnect connector E01 of ECM.
(e) Use a multimeter to measure the resistance
between the pin1 of DPF temperature sensor
connector Q01 and the ground.
Standard resistance
Multimeter connection
Standard value
pin
Q01（1）- ground ＜10 Ω
