Page 53 - CATALOG 2017

CURVED/WATERFALL TOP
AND CURVED LEG

I N S TA L L AT I O N

NOTE: Glass leg height will affect finished height. All measurements are approximate.
Make all final installation preparations after receiving the product for field verification
of final measurements.

���

25"

“L” Bracket 2 X 6 wall stud
recommended for
installation

����������

�������

Installation Procedure

NOTE: Installation recommends a minimum of 2 people to install correctly!

1. Measure from the floor up 32 1/4” to the top of the black granite, then level the
top perpendicular to the wall and secure the top to the wall. (2” x 6” wall stud
recommended for installation)

2. Place clear shims on the floor for the leg to rest on: one shim 1” in from each end
and one in the center.

3. Set leg bottom on top of shims and place top leg underneath the black granite
top.

4. Run a bead of silicone between the black granite top and the leg, and between
the leg and the floor. Trim off excess shim.

5. If using standoffs for the black granite top and the basin, put a small bead of
silicone on top of each standoff. Set basin on top of standoffs and center the
basin on the black granite top.

6. If the basin is pre-drilled for standoffs, set basin on top of the standoffs and
thread on the caps. Hand tighten only. Over tightening may cause glass basin
to break.

ALL MEASUREMENTS ARE APPROXIMATE +/- 1/4”.