Page 79 - hp server user guide_Neat

d. Route the power cable through the cable management clip, and then connect the opposite end of
the power cable to the connector on the system board.

14. If two eight-bay SFF drive cages are installed, install the storage controller ("Storage controller
options" on page 58).
15. Connect all necessary cables to the storage controller. For internal drive cabling information, see
"Storage cabling (on page 92)."
16. Remove the drive blanks.
17. Install the hot-plug drives ("Installing a hot-plug drive" on page 39).

CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.

18. Install the fans (on page 24).
19. Install the system air baffle (on page 22).
20. If removed, install the PCI air baffle ("PCI air baffle option" on page 57).
21. Install the access panel (on page 19).
22. Return the server to an upright position.
23. Connect each power cord to the server.
24. Connect each power cord to the power source.
25. Power up the server (on page 17).
26. Install and lock the tower bezel ("Install the tower bezel" on page 18).

Four-bay LFF non-hot-plug drive cage option

To install the component:
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 17).
2. Power down the server (on page 17).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Place the server on its side.

Hardware options installation 79