Page 21 - ZEN SERIES

Floor Restriction by The system can control the floor entry by giving key switch to authorized person. OPTION
Key Switch
Priority call in car or When the LOP or COP operated with VIP key switch, then elevator directly respond VIP call OPTION
Landing with Key by passing the other call.
switch
Automatic startup The system automatically implements startup torque compensation based on the current STD
torque car load, achieving smooth startup and improving the riding comfort.
compensation
2 way- Intercom An intercom system between the elevator and the master unit (in the supervisory panel, STD
System etc.) is provided for emergency communication purposes.

FRD -Phase 1 After receiving a fire emergency signal, the elevator does not respond to any call but STD
directly runs to the fire emergency floor and waits.

After the elevator enters the firefighter running mode, door open/close is implemented by STD
the jog operation (optional) by using the door open and close buttons rather than
FRD – Phase 2 automatically. In addition, the elevator responds to only car calls and only one call can be
registered once.
In automatic running state, when the elevator lock switch acts or the set elevator time is STD
reached, the elevator cancels all registered calls, returns to the elevator lock floor, stops
Elevator lock running, and turns off the lamp and fan in the car.
The system detects the running state of the elevator in real time. If the elevator speed STD
Runaway prevention exceeds the limit, the system immediately stops running of the elevator.
The system automatically judges the number of passengers in the car and compares it with OPTION
the number of registered car calls. If there are excessive car calls, the system determines
Anti-nuisance that it is nuisance and cancels all car calls. In this case, passengers need to register correct
function car calls again.
Full load By-pass If the elevator is fully loaded, this operation will not respond to any hall calls and will only OPTION
respond to the car calls.

Car Emergency light Emergency light in the car will start whenever there is power cut STD

Alarm Bell In case of emergency, the alarm bell will be activated by pressing the alarm button in COP STD
OLD – Over Load When the load of the car exceeds the rated capacity, Overload buzzer triggered and OPTION
Device message displayed in COP display. This operation opens the car door, will remain open until
load get reduce.
Interface for The system provides an interface for intelligent residential management to perform remote OPTION
intelligent monitoring on the state of elevators in the residential district.
residential
management OPTION
Car energy-saving- If there is no running command within the set time, the system automatically cuts off the
Auto Cut off power supply to the lamp and fan in the car.
In automatic running state, when the elevator speed is smaller than 0.2 m/s at normal stop OPTION
Door pre-open and the door zone signal is active, the system shorts the door lock by means of the shorting
door lock circuit contactor and outputs the door open signal, implementing door pre- open.
This improves the elevator use efficiency.

After landing at a floor, the elevator may move upward OPTION
Micro-levelling or downward due to the load change and the car door
is not aligned with the ground, which is inconvenient for in and out of passengers and
goods. In this case, the system allows the elevator to run to the levelling position in the
door open state at the leveling speed.
Automatic Rescue For the elevator configured with UPS, the system uses the UPS to implement low-speed OPTION
Device -ARD self-rescue in the case of power failure.

20
www.hephzi.com 2017