Page 235 - IE.IE Limited - Sealey Tools Catalogue

A
NEW
Vehicle Support Stands
A-B High Level Supplementary Support Stands
Model No. SEE BELOW
Designed to support part of a vehicle that is being used on a lift where free access is required. Stands also help prevent the tipping/rocking of the vehicle. Note: These stands should not be used to support a vehicle on their own. Sold singly but MUST be used in pairs.
B
B
NEW
A
B
235
Sold singly but must be used in pairs.
AB
Only to be used in conjunction with permanently fixed lifts, NOT mobile column lifts.
WHEEL CHOCKS
Always chock wheels that will stay in contact with the lift. See page 231 for full range.
Model No: Capacity Each: Minimum Height: Maximum Height:
AS2000HS
2tonne 1220mm 1800mm
AS4000HS
4tonne 1220mm 1855mm
VEHICLE SUPPORT & AXLE STANDS IMPORTANT SAFETY WARNING!
CNEW D
C - E High Level Commercial Vehicle Support Stands
Model No. SEE BELOW
Heavy-duty high level axle stands to safely support vehicles when workshop underside operations are being carried out. Independently UK load tested. Supplied with three interchangeable crutches for even load support. Heavy gauge steel frame and welded construction give superior strength and safety. Features captive, spring assisted, multi-position pin load support and castors for easy manoeuvrability. Ideal for commercial vehicles. Sold singly but MUST be used in pairs, or multiples of.
CDE
2
NEW
E
S
NEW
old singly but must be used in pairs.
WHEN JACKING A VEHICLE ALWAYS USE AXLE STANDS AND CHOCKS. NEVER GET UNDER A VEHICLE SUPPORTED ONLY BY A JACK.
1. Axle stands and High Level Vehicle Supports are capacity rated individually. Axle stands are sold in pairs and High Level Vehicle Supports are sold singly. A pair will normally support double the rated single load but be aware - you may know the total weight of the load you are supporting, but you cannot be sure that the load weight is spread evenly across both stands. For this reason always use higher capacity stands than you think you need.
2. Axle stands and vehicle supports are designed to support a static load in the middle of the engagement head (crutch). Take care to load evenly and never on the edge of the engagement head. Always take steps to ensure the load cannot move, use wheel chocks (see page 231 in this catalogue), apply vehicle brake and put in gear or "park".
3. All the axle stands and supports in this catalogue are designed for professional use and tested to ensure they meet or exceed International Standards.
1
3
Model numbers ASC50, ASC70 and ASC120 are all supplied with 3 different styles of crutch.
Model No: ASC50 Capacity Each: 5tonne Minimum Working 1315mm Height*:
Maximum Working 1835mm
Height*:
ASC70
7tonne 1315mm
1835mm
ASC120
12tonne 1340mm
1860mm
*measurements using crutch 1
For our full range of Commercial Wheel Removal Trolleys, see page 239
Follow these steps when using these stands and ensure adequate number of stands are used to fully support the load.