Page 59 - Mercury Repower Guide

ACCESSORY KITS FOR PLUS-SERIES ENGINES

ANALOG GAUGE INTERFACE KIT
POWER TRIM PUMP AND HARNESSES
TRIM PUMP ASSEMBLY

892486K08
Used on 14‑pin engines to convert a digital sensor signal into analog for
Tachometer, Oil Pressure/Oil Level, Water Temperature, Trim, and Fuel Level
analog gauges. There is also a connection for SC100 Link Gauges. Enhanced 865380A25
Voltage Suppression. Oildyne low pressure/high flow
Used with a 10 Pin Junction Box connection, For Non‑PCM09 ECUs ‑ Fits
SmartCraft compatible 14‑pin engines POWER TRIM EXTENSION HARNESS
MERCURY NMEA2000 SMARTCRAFT GATEWAY

MERCRUISER

84-817659T01
98-8M0151748 16 ft.(4.88 m) harness.
The Mercury NMEA2000 SmartCraft Gateway converts Mercury engine and This harness connects the remote control 4 pin Molex connector to the traditional 3
system data to NMEA 2000 for use on non‑Mercury gauges and displays for 1 to 4 blade Mercury pump trim pump connector.
engines. It also converts applicable NMEA2000 data to SmartCraft data for display MCM/MIE
by applicable SmartCraft gauges and displays. Includes a NMEA 2000 "T"
connector for quick installation. 84-881125A 1
Any instance where SmartCraft data is desired on the NMEA2000 bus. Applies to 24 ft.(4.88 m) harness.
single through quad engine applications. Not required when a MercMonitor, This harness connects the remote control 4 pin Molex connector to the traditional 3
VesselView Link or VesselView403, 502, 703 or 903 are being used. blade Mercury pump trim pump connector.
MCM/MIE
NMEA 2000 STARTER KIT
POWER TRIM EXTENSION HARNESS

8M0110642 84-865772T01
Kit includes NMEA 2000 power harness, 1 male termination resistor, 1 female 16 ft.(4.88 m) harness.
termination resistor and a "T" connector This harness connects the remote control 4 pin Molex connector to the newer
Whenever a NMEA2000 backbone is required, these are the basic components design 3 pin Packard pump trim pump connector.
required to start that architecture MCM/MIE

46 P/N 8M0150768