Page 188 - The ROV Manual - A User Guide for Remotely Operated Vehicles 2nd edition
P. 188
FIGURE 8.21
An epoxy or rubber insert (right) is soldered to wires, then overmolded with vulcanized rubber or polyurethane to produce the connector assembly (left).
FIGURE 8.22
A stainless steel guide pin assures correct polarity alignment prior to mating.
Over-molding
Over-molding (Figure 8.21) is a secondary molding operation.
Guide pins
Guide pins (Figure 8.22) are nonconducting pins used for alignment.
(Courtesy Ocean Innovations.)
8.2 Definitions 177
(Courtesy Ocean Innovations.)
