Page 22 - MUD-catalog-2019_Neat

UF 22
09/07 UF Quick-Change U-Style Shuttle

UF 321 Frame & Companion Insert Molds

Companion Interchangeable Insert Molds

1 Frame clamps at this end of insert mold.

Shuttle
Frame
ITEM NO. Standard Solid: T-Style Solid or Optional
6.0 x 6.75
Laminated: 9.0 x 6.75
09/07 UF 321 1 .31 1
UF 321 Frame Upper – Side View 6.000 .437 Ejector .562
6.000
Half
.75 1.50 6.750 Ejector 6.750 Half
1.06
UC 3816 .60 .75 .437 .562
.44 .562 ± .001 .687 5.25 Ø 5/16 Hardened runner pads
Offset 5.996 Offset 9.000 Dowel available (quotation on
UF 321 Frame Upper – Top View 6.456 request).
MUD Quick-Change Mold Frames & Inserts for U-Style | 09/07 UF 321
1/2-13 THD (4) .246
.246 6.456 ± .001 .75
1.50 .230 .75 .230 5.996
A A A2
A2
Ø .375 Ø .500

Cavity half, one (1) required. B2 B2
B B
UF 321 Frame Lower – Side View .75 .75
3/8-16 THD .75
Ø 2.00 .250 2.00
Standard Solid Construction
.255 .253 ITEM NO. A A2 B2 B
Ø 1.75 09/07 SSU 221 2.250 1.500 1.500 2.250
1.25
UF 321 Frame Lower – Top View
T-Style Solid Construction
3/8 x 5°
+.002
6.000 -.000 Lead ITEM NO. A A2 B2 B
09/07 TSU 241 2.250 1.500 1.500 2.250
2.00
4.250
6.000 T-Style Laminated Construction
6.75
ITEM NO. A A2 B2 B
09/07 TLU 201 2.250 1.500 1.500 2.250
1.750 2.50 .75
9.00 .375 Ordering information for frame and
Drill & C’Bore for companion insert molds can be found
1/2-13 SHCS (4) in the front of this section.
Ejector half, two (2) required.
KO Rod Spacer NOTE: When ejection is required, pockets
can be machined in ejector half of insert
.25 mold and ejector plates installed.
1.245 Two (2) required.
Knockout rod spacer
Ø 1.745 Ø 1.980 standard as shown.

NOTE: Insert molds can be ordered with two (2) “B”
halves by noting “S” after catalog code number.

U.S. 800-626-6653 n www.dme.net

Canada 800-387-6600 n Mexico 52-442-713-5666