Page 143 - Hot Runner & Control Systems 2020

Smart Series ®
140

RoHS/WEEE Compliant: Mold Power Input Connectors

For 15 AMP Mold Power Input Connectors are mounted on the mold to accept power cable(s) from
Applications the Mainframe. They are supplied with six inches of numbered leads and a ground wire.
All three 15 AMP connectors are the same physical size and use 14-gauge wire. Only the
number of active pins change. The 30 AMP connectors are supplied with 10-gauge leads
and are attached to screw terminals. Each is equipped with an integral retaining latch to
provide a secure cable connection. Connector configuration ensures proper insertion of
PIC5G
cable. Splicing of 6" leads to heater power leads is easily accomplished with the Insulated
Crimp Connectors supplied.

NOTE: Ground wire must be
connected to mold to
ensure operator safety.

PIC8G Mold Power Input Connectors

PIC12G

For 30 AMP NOTE: Replacement parts and
Applications extraction tools can be Smart Series ® | Mold Power Input Connectors
found on page 146

NOTE: Dimensions shown may vary slightly.

PICH23G Insulated Crimp Connectors

PICH5G
NOTES: NOTE: Initial supply is provided with
Connector PICH23G is mold power input connectors.
dimensionally identical to Also, see page 126.
thermocouple connector
MTC8G. See next page.
For PICH23G and PICH5G,
direct wiring without crimp
connectors is possible by
removing 6" leads.
U.S. 800-626-6653  Canada 800-387-6600  dme@milacron.com  www.dme.net