Page 258 - Mold Bases & Plates 2020

Mold Plates
266 266
Spacer Blocks
Angle Spacers – DME No. 1 Steel

Riser height (“C” dimension) is finish ground L 3
to a tolerance of plus or minus .001".
These Angle Spacers are useful for the 1 4
1
buildup of Compression Mold Assemblies.
C

1 R.
4
1
1 2
AUXILIARY SPACER PLATENS
When the use of Auxiliary Spacer Platens becomes necessary to reduce the
minimum daylight of the press, the importance of proper rigidity cannot be over-
emphasized. The drawing shown here illustrates a typical installation that meets
good rigidity requirements. The distance between the parallel spacer blocks is
dependent on the location of the knock-out rods on the press.
ITEM
L C NUMBER NET MIN. DAYLIGHT
WT.
MOLD SHUT HEIGHT
3 30-312 22 DME MOLD
12 4 5 40-312 27 CLAMP
50-312
32
6 60-312 37
3 30-315 28
15 4 5 6 3 40-315 34 MACHINE PLATEN MACHINE PLATEN
50-315
Mold Bases and Plates | Index Mold Plates | Spacer Blocks, Angle Spacers – DME No. 1 Steel 18 4 5 6 3 4 5 6 40-318 41 The drawing shown below illustrates a recommended design that is available from DME on
40
60-315
47
33
30-318
DME DIE
50-318
48
CLAMP
56
60-318
SPACER PLATEN
30-320
37
40-320
45
20
54
50-320
special order. The use of standard DME mold plates and spacer blocks can help keep the
60-320
62
cost at a minimum. A detailed drawing should accompany your request for a quotation.
53
40-324
3
23 ⁄4
64
50-324
60-324
6 3 4 5 30-324 43
74
3 30-326 47
26 4 5 40-326 59
70
50-326
6 60-326 81
3 30-329 54
1 4 40-329 66
29 ⁄2 5 50-329 79
6 60-329 91
3 30-335 65
1 4 40-335 80
35 ⁄2 5 50-335 95
6 60-335 110
WHEN ORDERING, PLEASE SPECIFY:
1. Quantity
2. Item Number
3. Method of Shipment
U.S. 800-626-6653 ● Canada 800-387-6600 ● sales@dme.net ● www.dme.net
U.S. 800-626-6653 ■ Canada 800-387-6600 ■ sales@dme.net ■ www.dme.net