Page 2 - Parker - Fulflo ParMax SELECT Filter Cartridges

P. 2

™
Fulﬂ o ParMax SELECT Cartridge

ParMax Select High Flow Cartridge
™

SELECT-Pleating

guard
core

standard pleating
With Select Pleating, there is more open area
on the inside of the cartridge for additional
Note: The 2.9˝ inlet oriﬁ ce of the ParMax Select Cartridge is the ﬂ ow-limiting factor contaminant-holding capacity.

Materials of Construction: Dimensions (nominal): Recommended Operating
• Media: Outside Diameter: 6.0˝ (15.24 cm) Conditions:
RSCP - Polypropylene Inside Diameter: 2.9˝ (7.36 cm) • Flow Rate:
RSMG - Microfi berglass Up to 175gpm (662 LPM)/
• Support/Drainage: Maximum Operating 20˝ element
Polypropylene Conditions: Up to 350gpm (1325 LPM)/
• Hardware: Polypropylene • Maximum Temperature: 40˝ element
• O-Rings (SOE): 176ºF (80ºC) @ 30psid (2.1bar) Up to 500gpm(1892 LPM)/
®
EPDM, Buna-N, Viton , Silicone 60˝ element
• Maximum Differential Pressure:
70psi (4.8bar) @ 77ºF (25ºC) • Change-out Pressure:
Retention Ratings (99.98%): 35psid (2.41bar)
30psi (2.1bar) @ 176ºF (80ºC)
• 1, 3, 4, 5, 10, 20, 30, 40, 90* µm

Ordering Information

Cartridge Code Micron Rating Length Seal Material End Cap Conﬁ guration
Code Description Code μm Code Inches Code Description Code Description
RSCP Polypropylene 010 1.0 20 20˝ (50.8 cm) E EPDM PP 435 O-ring/Closed
RSMG Glass 030 3.0 40 40” (101.6 cm) N Buna-N
045 4.5 60 60” (152.4 cm) S Silicon
100 10 V Viton ®
200 20
400 40
900* 90
* Available only in polypropylene media (RCP)

Speciﬁ cations are subject to change without notiﬁ cation. © 2010 Parker-Hanniﬁ n Corporation
For User Responsibility Statement, see www.parker.com/safety domnick hunter Process Filtration - North America
All Rights Reserved
Fulﬂ o is a registered trademark of Parker-Hanniﬁ n Corporation
Viton is a registered trademark of E. I. duPont de Nemours & Co.
DS_IP_ParMax Select Rev. A

1 2