Page 132 - Parker - Vacuum products

Catalog 0802-E Pneumatic Control Components
Cautions Technical Data

! Cautions Installation
Pressure sensors are designed to monitor pressure and are not • Never insert an object into the pressure port other than an
a safety measure to prevent accidents. appropriate fluid connector.
• Avoid short-circuiting the sensor. Connect the brown lead to
The compatibility of the sensor is the responsibility of the V+ and blue lead to 0V.
designer of the system and specifications.
• Do not connect the output lead wires (black / white) to the
Operating environment power supply.
• Parker sensors have not been investigated for explosion- • Outputs not being used should be trimmed and insulated.
proof construction in hazardous environments. • Install as shown using the metal mounting bracket.
• Do not use with flammable gases, liquids, or in hazardous
environments.
• Avoid installing the sensor in locations where excessive Pipe Plug
voltage surges could damage or affect the performance of Ambient Air
the sensor. Inlet Port
Operations Barb
C • Dedicate a power supply of 10.8 to 26.4VDC to the sensor O-Ring Coupling
–INCLUDED–
and set the ripple to Vp-p10% or less. Avoid excessive
voltage. Avoid voltage surges.
• A small amount of internal voltage drop is possible. Ensure
the power supply minus any internal voltage drop exceeds
the operating load.
• Verify the operating media is compatible with the
specified sensor. Check the chemical make-up, operating
temperatures, and maximum pressure ranges of the system
Technical
before installing.
• Installation of air dryer system is recommended to remove
moisture.
MPS-33

MPS-34

SCP01

SCPSD

Glossary
Symbols,
Accessories,

C2 Parker Hannifin Corporation
Pneumatic Division
Richland, Michigan
www.parker.com/pneumatics