Page 2 - Parker - ParMax Select Cartridge

ParMax Select Cartridge
™

ParMax Select High Flow Cartridge
™

With Select Pleating, there is more
open area on the inside of the
cartridge for additional
contaminant-holding capacity.

Note: The 2.9" inlet orifice of the ParMax Select Cartridge is the flow-limiting factor

Materials of Construction: Dimensions (nominal): Recommended Operating
• Media: Outside Diameter: 6.0” (16.51 cm) Conditions:
MCPS - Polypropylene Inside Diameter: 2.5” (6.35 cm) • Flow Rate:
RMG - Microfiberglass Up to 175 gpm (662 LPM)/
• Support/Drainage: Maximum Operating 20” element
Polypropylene Conditions: Up to 350 gpm (1325 LPM)/
• Hardware: Polypropylene • Maximum Temperature: 40” element
• O-Rings (SOE): 176ºF (80ºC) @30 psid (2.1 bar) Up to 500 gpm(1892 LPM)/
EPR, Buna-N, Viton*, Silicone 60” element Change-out
• Maximum Differential Pressure: Pressure: 35 psid (2.41 bar)
70 psi (4.8 bar) @ 77ºF (25ºC)
Retention Ratings (99.98%): 30 psi (2.1 bar) @ 176ºF (80ºC)
• 1, 3, 4, 5, 10, 20, 30, 40, 90**
Ordering Information

PP

Cartridge Code Micron Rating Length Seal Material End Cap Configuration
CODE DESCRIPTION CODE (µm) CODE LENGTH (CM) CODE DESCRIPTION CODE DESCRIPTION
RSCP Polypropylene 010 1.0 20 20” (50.8 cm) E EPR PP 435 O-ring/ Closed
RSMG Glass 030 3.0 40 40” (101.6 cm) N Buna N
045 0.45 60 60” (152.4 cm) S Silicone
100 10 V Viton ®
200 20
400 40
900* 90
*Available only in polypropylene media (RCP)
© 2008 Parker Hannifin Corporation Bulletin C-2062A 05/08
* Trademark of E. I. duPont de Nemours & Co.
** Available only in the CP version